![]() Using the standard hand mic speak 3 fingers width away at a 45 degree angle so that you are speaking accross the mic for the best audio.ĭesk and boom mikes speak 3-4 fingers width away and speak directly into the mic for best audio. ![]() Heil ICM mics or Elite headsets = bass -1 treble +4 This is your tone page where you set the bass/treble to match your microphone.Īny "SM" mics like the SM-30 or SM-50 as well as Heil PR-781/PR-40 = Bass -1 Treble +4 If you don't see TONE, press the arrows in the lower left of the screen which moves the readout up/down, or turn the multi knob. The first is below the scree the rest is on the screen. (use 95% is you're using a dynamic microphone) The comp should be set to 5%. To the right make sure the TBW (transmit bandwidth) is set to WIDE. This must be turned on for your compression to work. Look at the top center or bottom of the page to make sure the COMP = ON Press open the Function page (next to the menu below your screen) Running the compression at 3 gives the audio a well rounded response and is not too much, be sure to keep the mic gain set so that the ALC is at the lower to mid range on the meter, don't go any higher that half scale as it will begin to overdrive. I have tried many mics on this rig and have found that the Heil PR-781 is best suited. ![]() Press these names below in sequence to open the Tone page. Getting to your Tone page is a little different. Your mic and compression levels are the same as the 7300. The All Reset is best but will remove any FT8 Settings. If any settings refuse to work, doing an All-Reset should fix the problem. Headphones - set the mike element just to the left of your mouth 3 fingers away for your best audio. Std Hand Mic speak 3 fingers away at a 45 degree angle for best audio.ĭesk and Boom mikes speak 4 fingers away directly into the microphone. Bass 0 Treble +4 (includes Heil 781 and PR40 microphones) This is your Tone Page where you set your Bass, Treble to match your microphone.Īny SM mic like the SM-30. If you don't see TONE, press the arrows in the lower left of the screen which moves the readout up and down. The first is below the screen the rest is on the screen. (use 95% if your using a dynamic microphone) The Comp should be set to 5%. To the right make sure the TBW (bandwidth) is set to WIDE. This must be turned on for your Compression to work. Look at the top Center or Bottom of the page to make sure the COMP = ON Press open the Function page (next to the Menu below your screen) IF you choose to run the Mic EQ, then you would use these settings The rest are default settings except to have the TX BPF at: 200-2800, this can vary depending on your voice These settings are credited to a great friend Randy/K0RWB.thanks Randy!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |